- May 19, 2008
- 148
- 2
- 111
This is just like the other feeder just using another connection method.
This time I used metal fabric pins, that you get for holding down weed barrier. Some local lawn and garden places sale these. Hardware store would prob have something that would be close too it.
My overview shot.
To connect the pipe to the pan all you need to do is drill 4 holes in both the pan and the pipe. Then run the pins through the holes. Remember two of the holes need to be drilled higher so the pins don't meet in the middle at the same level. Here shows the holes.
Here is a view down the stove pipe.
I can hang these or leave them on the ground.
Good Luck
Nick
This time I used metal fabric pins, that you get for holding down weed barrier. Some local lawn and garden places sale these. Hardware store would prob have something that would be close too it.
My overview shot.
To connect the pipe to the pan all you need to do is drill 4 holes in both the pan and the pipe. Then run the pins through the holes. Remember two of the holes need to be drilled higher so the pins don't meet in the middle at the same level. Here shows the holes.
Here is a view down the stove pipe.
I can hang these or leave them on the ground.
Good Luck
Nick
Last edited: