I’m setting up my Maxi II Ex incubator and had a question. The printed manual in the box said to cut the evaporation card to 1 3/4in by 5in. I did that and put it in the water pot as stated (folded in half and making sure the ends reach the bottom of the water pot). When I put the top of the incubator on, then the evaporation card sticks up and hits the incubator top and I don’t know if the incubator is completely sealed. I found a manual online and it says the evaporation card should be 4in long. Should it be 4 or 5 inches long? I can cut off an inch. Also the width is a little too much too (I had to bend the evaporation card to fit it inside the water pot). Thank you for your help!
@BrinseaUS
@BrinseaUS