Ok! Wow, what a tight fit... LUCKILY, I got a hold of the person with the brown chinese eggs and they are not coming until next week. By then I will have moved 2 more over to the hatcher... because I am getting 2 extra eggs!
In case you are wondering wth that thing is in the basket with the wire attached... that is a goose size easter egg with hair gel and a temp-sensor positioned in the center. I got it to position exactly center with some paper clips and twistie ties. Not my idea, saw someone else here who did it but I couldn't find a big enough water wiggler so I did the gegg (gel-egg).
My only concern with the whole deal is that the tops of the eggs seem close to the heating unit on the outermost baskets. If the egg sensor tells me its getting too toasty in there I will take out the cut up rags to make more room between the egg and heat coil. That should take them down at least a 1/4 inch and I would be less worried.
Editing to say that I did have to remove the frame and go back to tape to keep the triangles together. My thermometer was indicating that the temp inside the egg was getting hotter than the air temp so I guess they were too close to the heating coil. I noticed this pretty quick as I have been monitoring them every 10-20 mins! So now the wood triangles are attached with tape in the same fashion that the cardboard ones were before. Now, the temps are evened out and air temp and egg temp are much closer to each other.