Helpful hints for building coops

[CapricornFarm]

Personally, I would use the cane rather than fall down. My big feet get tangled in everything!

 

[jvls1942]

When I go outside I use a walker but inside the house I can get around without a cane

 

[3KillerBs]

When I go outside I use a walker but inside the house I can get around without a cane

When I had to learn to walk again after a blood clot I was supposed to use the cane all the time but kept finding that I'd gotten distracted and walked across the room without it.

 

[CapricornFarm]

I cut and painted 2 more pieces of plywood today and made an isolation cage in case a chicken gets sick.
Will be very happy when winter weather goes away.

 

[jvls1942]

I took the plunge and tried the stairs. so, here I am, down in the basement and on the computer.
I had to log in in order to reply. I guess two weeks is too lone for them to wait for a person.
I have a ton of emails and un-solicitated junk to delete. I will be busy for awhile..
It is nice to type the words instead of talking on the i phone..
.......jiminwisc......

 

[Molpet]

I took the plunge and tried the stairs. so, here I am, down in the basement and on the computer.
I had to log in in order to reply. I guess two weeks is too lone for them to wait for a person.
I have a ton of emails and un-solicitated junk to delete. I will be busy for awhile..
It is nice to type the words instead of talking on the i phone..
.......jiminwisc......

Hope getting up the stairs is good too.
Much easier to type on a keyboard

 

[aart]

I took the plunge and tried the stairs.

Welcome Back Jim!!

Hope getting up the stairs is good too.

Ditto Dat!

 

[CapricornFarm]

Today I cut and painted more plywood. Only one small piece to cut! Hope to install tomorrow.

 

[RawEggEater]

... the torx head screws, they do resemble six pointed stars. I even have some but can never seem to locate the bit used for them. ...

Use the T25 bits and not the T20's. The T20's are terrible. If they round out the screw, they will ruin the bit and then be more likely to round out the next screw. That won't happen as much using the T25's.

 

[aart]

Use the T25 bits and not the T20's. The T20's are terrible. If they round out the screw, they will ruin the bit and then be more likely to round out the next screw. That won't happen as much using the T25's.

No doubt, the larger the better.