No. It's routed between 2 pulleys that are side by side. One of them has to come off 'cause there's no room for the belt to fit between the pulley flanges. I can't get a wrench on it to loosen it.that's awesome
Speaking of which. Did you get that drive belt back on?
Why would you need to fit the belt between the pulley flanges? Or do you mean no room to slip the belt into the pulleys? Is there a tensioner somewhere on the belt? There should be at least.
That's what I thought, too, but haven't had any luck yet. I can't even see the bolt head, no room to get a hand on it, so I don't even know if I've got the right wrench. Worst part is, I've changed that same belt before, but it's been so long ago I can't remember what I had to do...only remember it being a major PITA
Both pulleys are stationary, but the belt goes on opposite sides of them. They're too close for the belt to go between the flanges w/o driving it into place,which would cut the belt, and that belt ain't cheap.
It's a Dixie Chopper, I'm thinking 1997 (?). I don't think you'll find anything. I tried to find a Shop Manual for it last night, in a PDF...drew a blank. The pulleys are on the mower deck, which is 60"
