This is not my work, but I found it open source. This is the 3d print file for a divider to go inside the trays. I printed them and they work great, I was using hair ties before that (also not my idea).
I print from ultimaker cura and it fits perfect.
I also have the 2 files for the big divider to partition off the bottom of the incubator during lock down but its a bit wonky, I had to cut it in 1/2 because its too big to print on my 3d printer then glue the two halves together. Im goig to try and make it a dovetail joint for the two halves and clean it up a bit. I will post once its done.
I print from ultimaker cura and it fits perfect.
I also have the 2 files for the big divider to partition off the bottom of the incubator during lock down but its a bit wonky, I had to cut it in 1/2 because its too big to print on my 3d printer then glue the two halves together. Im goig to try and make it a dovetail joint for the two halves and clean it up a bit. I will post once its done.
