LaurelAvenue
In the Brooder
- Nov 7, 2018
- 7
- 4
- 11
i built a PVC pipe feeder using plans I found on the internet. However it doesn’t appear that gravity alone is going to do the job to pull the crumbles down the pipe, through the elbow connector and into the feeder section (with holes cut in it for the hens to feed out of). Does anyone have any advice for solving this problem? Would pellets work better than crumbles?
Also, my crumbles are getting damp inside the long, primary pipe. I don’t know if this is from humidity or whether it’s the little bit of rain we’ve been having. The end of the pipe has a screw in cap rather than an over-the-top end cap. Do you think that an over-the-top end cap would solve the dampness issue?
Also, my crumbles are getting damp inside the long, primary pipe. I don’t know if this is from humidity or whether it’s the little bit of rain we’ve been having. The end of the pipe has a screw in cap rather than an over-the-top end cap. Do you think that an over-the-top end cap would solve the dampness issue?