Rcom Suro King Incubator official thread ***HIGH ALERT***see post 93

[berkeleysprings]

I've had that incubator for many yearsI don't think it matters that much that the eggs are upright in the nest with a hen they are not upright

 

[LDR2]

I'm setting up my Rcom. Does anyone know why the water isn't being pumped. I've pressed the "+" for 5 and 10 seconds

 

[1-duckling]

Hi! The water pump runs for short durations and takes me about six times of holding the button down until the second beep to get the water to the incubator.

Only time it wouldn't was when the hose got a hole. And that time the hose curled up in the jar too far and sucked air.

Were you able to get yours to work?

 

[LDR2]

Yes ! Thank you. I figured it out last night. It took about 15 minutes to get the water to the incubator but after that it worked perfectly.

Hi! The water pump runs for short durations and takes me about six times of holding the button down until the second beep to get the water to the incubator.

Only time it wouldn't was when the hose got a hole. And that time the hose curled up in the jar too far and sucked air.

Were you able to get yours to work?

 

[vaggelisz]

For those who has used the Suro. What you think would be the ideal temperature and humidity for bantam eggs. I am about to use mine for the first time. Should i use it with the factory settings?

 

[Lynnpickel]

How do I reset the APS on the RCom so I can start a new hatch

 

[mhunter944]

Hi, hope folks are still reviewing old threads! I just got the king auto and this is my first time trying to hatch anything. I am at a complete loss trying to assemble this as the humidity pad instructions are really confusing me. Do I cut this pad into three pieces, no matter what? Or do I need to figure out my settings first then decide how much to use? What is the humidity level supposed to be for Silkie eggs, and does it matter at all that my bathroom is currently at 31% humidity?