This is exactly the person and size I got off e-bay,
http://www.ebay.com/itm/2-HEAVY-KNO...OLYETHYLENE-NOT-NYLON-/280812565125?pt=LH_Def It came in a box measuring about 2'x1.5'x1' on size,,I first took out of the box,and unrolled it so it resembled a long tube,and since the measurements was identical for width,it didn't make any diffrence which way was which. I then used a step ladder and took this long "tube" shaped piece of netting and laid it all along one end atop the posts. If you read thru this thread,I started using 3/16"? aircraft cable between the wooden poles,I went straight both ways,then diagonal between them so there is an X shape between 4 poles,as well as a square around them. It is very hard to lose the netting between so much support,so once the netting was laying all along one end,I then used a long pole to push the netting up,and begin unrolling it across the wire.It took awhile since I already had the sight barrier and 2"x4" welded wire up seperating the pens but it was easy to push it up,and about 5' would unroll.
I went way overkill using the aircraft cable,and when I ran out used galvanized 12 gauge wire to finish with,,much easier to work with and stretch tight compared to cable.I have a friend closeby that made a framework using pcv plastic pipe,then he unrolled his net on top,then pulled this framework up,and attached to his guide wires which ran from end to end. He didn't have any posts in the middle of his big flight pen,so it was possible to pull up a section at a time,to the height he wanted and tie it off.His netting looks suspended and is a lot tighter than mine is.