wells different looking in hovabator 2362N than in instructions

[wahmommy]

Hi, I am borrowing a hovabator 2362N and I downloaded the instructions https://www.gqfmfg.com/pdf/circ%20instructions.pdf but the wells that you fill with water look very different in my incubator that what they have in these instructions. The wells on either side kind of look flag shaped.. anyway, does anyone know which wells I fill when?

 

[dbcooper02]

Here's a scan of the applicable instructions for the one you are using.

 

[wahmommy]

thank you thank you I've been filling the trough on the far left LOL. I am going to start incubation on Saturday so THANK YOU

 

[mstricer]

I have had better luck with my 2362n, doing a dry hatch. Then adding water the last 3 days, good luck I'm setting Sunday night.

 

[wahmommy]

I actually decided to do a dry hatch, but I have two hygrometers and they both read something different (even though I calibrated both with the salt test..:|) I ordered a special hygrometer one step calibration kit and I'm going to calibrate them again but right now the acurite reads anywhere from 25% to 16% with no water, the other hygrometer is reading between 30 and 40. So I'm trying to figure out if I can just put a minimal amount of humidity in there to keep the acurite above 25% all the time - at least til I get the calibration kit and make sure I know what the actual humidity it is. So I probably won't use the wells after all

 

[wahmommy]

I'm going to set the eggs on Saturday