I'm sad to report that is me.  The run is built with a 4x4 center pole.  I attached the first four rafters the in the center of each side and then added the rafter from each corner.  The additional rafters are added for a total of 12.  It requires a seat cut at the fence and first four rafter require a angle cut.  The next rafters require angle and bevel cuts.  Sounds complicated but it really isn't.  When you use a star plate you will have to build to sizes and pitch dictated by the plate.  
The ex-wife coop has a gambrel roof and the rafters are quite easy to cut. I built it without using a plan but when I get back from Missouri at the end of the month I will try to find so time to draw up plans and make a cut list that shows the board lengths and angles.
	
		
			
		
		
	
				
			The ex-wife coop has a gambrel roof and the rafters are quite easy to cut. I built it without using a plan but when I get back from Missouri at the end of the month I will try to find so time to draw up plans and make a cut list that shows the board lengths and angles.
	
	
	
	
	
	
	
	