
Yesterday I had to cut down a large, maybe 18-20 inch round tree that the top half cracked off last year in a wind storm. My biggest battery chainsaw is my Ryobi 40v 14 inch chainsaw. Normally, I would never consider using a 14 inch chainsaw to cut down a tree with a trunk that is maybe 6 inches wider than my chainsaw blade is long. Felling a large tree is not something I think my 14 inch Ryobi 40v chainsaw was designed for and I did not think it would be up to the task. However, I thought I would give it a try to test the limits of the chainsaw.
[Edited: Added picture of tree that I felled. It was 19 inches across.]
.
I was able to successfully fell the large tree, but it took me almost 2 full batteries just to get the tree down on the ground. I had enough juice left in the second battery to limb most of the branches, and then it was spent. I don't know how well other battery powered chainsaws work, my little Ryobi cuts well with a sharp blade, but I got maybe only 20-25 minutes run time total from my 2 batteries, and then it was done for the night and time to recharge them. For anybody switching from gas to battery yard equipment, I think the first challenge to recognize is that you have pitiful runtime on most batteries, and if you don't have multiple extra batteries, you will get part way into a large project but probably have to spread out the work over a number of days. Especially with battery powered chainsaws.
Today, I went back out to that large tree and cut almost 5 rounds off the trunk before the batteries were spent. At this rate, I have another 3 days of work on this project. With a high drain device like a chainsaw, the batteries work hard and heat up. So when the battery is exhausted, you cannot just put it on the charger and start charging it. No, you have to wait almost an hour before the battery is cool enough that the charger will even start to recharge the battery. Then it takes maybe another 2 hours to charge the battery. Again, if you don't have multiple batteries, your downtime with battery powered tools can be really long.

Another advantage to battery powered chainsaws is that it always runs with a freshly charged battery. I cannot tell you how easy it is to just drop a battery in the chainsaw and clean up a few fallen branches after a storm, and putting the chainsaw back in the garage. Back in the day, with my gas chainsaws, I might spend more time trying to get the stupid gas chainsaw even running! Unfortunately, that is true. If you don't use a chainsaw very often, the gas can go bad and foul the carburetor, causing all kinds of problems. Since I don't use my chainsaw very often, and usually it's only small to medium jobs when I do, my little Ryobi 14 inch 40v chainsaw is more than adequate for those jobs.
Many times I have to go and clean up a fallen branch or two after a wind storm, and in about 10 minutes the battery chainsaw will have everything cut up and ready to be hauled off to the wood pile. For those small jobs, the battery chainsaws really come out on top.
Another advantage to buying into these tool lines, is that my chainsaw battery also works in my grass trimmer, lawn mower, power sweeper, leaf blower, and cultivator for the raised beds. I really don't use my chainsaw very much, but I use my grass trimmer all the time. I also use the cultivator not only for the raised garden beds, but also for mixing up potting soil and compost when I want. Fortunately, the batteries usually last a lot longer with my other outdoor tools compared to the high demand chainsaw. I usually have more than enough battery run time for my non-chainsaw tools, allowing me to complete almost all tasks I need to do around the house.
Well, that's about it. I'm just burning some time on the BYC forums while my chainsaw batteries are on the charger.....
Last edited: