Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
And my roof leaks because I didn't remove the burr left behind by the drill.This is what I used:
Wow that’s a neat drawing! That helps a ton! I’ll show it to hubby. How do you think it will do in the snow?Black is angle ripped 2x6 extending out 6+ inches past the end of the "run".
Red are 1x ripped down 2x6 set 16" OC to form purlins with as much overhang left/right as the roofing will allow.
View attachment 3254212
Polycarbonate roofing, 26"x12'
Cut in half with the blade turned around backwards to make two panels 6' long.
View attachment 3254216
Screw closure strips over the purlins.
View attachment 3254219
Secure roofing over the closure strips with gasket sealed panel screws over each high spot on the roof panel. I have a huge bag of these left over from the polycarb roof I installed on my run.
View attachment 3254223
So helpful to see the stuff installed! Thanks.This is what I used:
Don’t those screws use a rubber washer to seal the hole?And my roof leaks because I didn't remove the burr left behind by the drill.
Yes, but the hard plastic slivers didn't allow it to seal properly.Don’t those screws use a rubber washer to seal the hole?
The burr needs to be removed or I suppose a different bit could be used.Yes, but the hard plastic slivers didn't allow it to seal properly.
Mine held up just fine to the 3.5' we had last year.Wow that’s a neat drawing! That helps a ton! I’ll show it to hubby. How do you think it will do in the snow?
I can install that when I do the vent.I’m sold on Tonya’s design! When We get back from GA I’ll buy the parts! Thanks Tonya!