Need roof over 4x5 run

[StinkyAcres]

So how do people attach polycarbonate pieces.

This is what I used:

 

[StinkyAcres]

This is what I used:

And my roof leaks because I didn't remove the burr left behind by the drill.

 

[CarlaCo]

Black is angle ripped 2x6 extending out 6+ inches past the end of the "run".
Red are 1x ripped down 2x6 set 16" OC to form purlins with as much overhang left/right as the roofing will allow.
View attachment 3254212

Polycarbonate roofing, 26"x12'
Cut in half with the blade turned around backwards to make two panels 6' long.

View attachment 3254216

Screw closure strips over the purlins.
View attachment 3254219

Secure roofing over the closure strips with gasket sealed panel screws over each high spot on the roof panel. I have a huge bag of these left over from the polycarb roof I installed on my run.
View attachment 3254223

Wow that’s a neat drawing! That helps a ton! I’ll show it to hubby. How do you think it will do in the snow?

 

[CarlaCo]

This is what I used:

So helpful to see the stuff installed! Thanks.

 

[CarlaCo]

And my roof leaks because I didn't remove the burr left behind by the drill.

Don’t those screws use a rubber washer to seal the hole?

 

[StinkyAcres]

Don’t those screws use a rubber washer to seal the hole?

Yes, but the hard plastic slivers didn't allow it to seal properly.

 

[StinkyAcres]

Yes, but the hard plastic slivers didn't allow it to seal properly.

The burr needs to be removed or I suppose a different bit could be used.

 

[DobieLover]

Wow that’s a neat drawing! That helps a ton! I’ll show it to hubby. How do you think it will do in the snow?

Mine held up just fine to the 3.5' we had last year.

 

[CarlaCo]

I’m sold on Tonya’s design! When We get back from GA I’ll buy the parts! Thanks Tonya!

 

[DobieLover]

I’m sold on Tonya’s design! When We get back from GA I’ll buy the parts! Thanks Tonya!

I can install that when I do the vent.