Separate names with a comma.
Discussion in 'Incubating & Hatching Eggs' started by AmyLynn2374, May 8, 2015.
The membrane is looking dry and it has been about 24 hours since the breach pip.
That wasn't me being mean Mr. Flock to be funny. That's my philosophy, and the number one reason Amy and I started this thread. Y'all have your ways, I have mine, and we present both sides.
So YOU shut YOUR face
If that one's going to hatch, it will have to be assisted, and that's not my thing, so I will step back and watch. Good luck
I am going to wait until the one that pipped around the same time to hatch before I start the assist. Cheers.
Ok. The low humidity alarm is AS. Factory default is 45%.
Might as well post them all
AL -low temp alarm
AH -high temp alarm
CA -calibrate the temp sensor
HS - temp high limit
LS - temp low limit
Hope that helps!
You just knew you were gonna get major slapped if you did! Lol
Looks pullet to me too. I have 3, and 2 crests hang down the back much longer than the other 1. Might that indicate 2 girls and a boy?
I don't know but she sure is pretty.
Personally, with the membranes starting to turn yellowish I would add moisture with a q-tip and consider an assisted hatch if the blood vessels are shrunk and absorbed.
TY very much. I just hope she knows how to reset it....lol
Press and hold SET until a code comes up, hit + or - to get to the right code, then + or - to change the value.
Thanks! Great! I'll relay it.
I ain't scared of none of Ya.
I'm horrible at guessing polish, but usually the ones with the crests further down the back are boys, but I have been wrong selling them that way. I'm not certain until the wattles start developing around 8-10 weeks
Thanks Amy I have just turned on my cooler bator to heat up so I will use that for the assist on when it gets up to temp. So I don't have to disturb the others.