Anyone know what wires go where on a Little Giant Thermostat?

For the record, the wires in question are:

Thick Black wire from the heat element

Thick white wire from the heat element

Power supply cord, which one side is ribbed

Power supply cord other side smooth

From Controller:

Thin red wire

Thin Black wire

Thin White wire
 
I know this thread is old, but I have a similar question. In my case I wanted to add fan to my ancient still air Hovabator from about 20+ years old. I decided I would also convert it to a picture window one at the same time. The fan is completely independent and has it's own cord so I am good on that, but need help with reconnecting everything for the heat I have. all the construction done and now only need to connect the wiring but do not want to short everything out. I actually did write down what connected where but since this has been an ongoing project since about February the paper has been misplaced. I am really only reconnecting the same things that were already there, but bought a new wafer thermostat and heating element...both of which came with no instructions. The components that need to connect are as follows:

Power supply: Using the original power cord with one smooth side and one ribbed side

Thermostat: New GQF wafer thermostat with 2 blue wires

Indicator light: 1 white and 1 light blue wire

Heating element: New GQF element with one black wire and 1 blue wire.

 

New posts New threads Active threads

Back
Top Bottom