- Thread starter
- #41
Thank you, you're an angel! Time to go test it out.All you need to do is hold down the okay button, then hit the plus and minus at the same time. It will make the turner engage!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thank you, you're an angel! Time to go test it out.All you need to do is hold down the okay button, then hit the plus and minus at the same time. It will make the turner engage!
It might take a few times to figure it out and make it work, but keep trying! I often end up going through the whole menu a time or two before I get it to work!Thank you, you're an angel! Time to go test it out.
Oh no, it puts me into the calibration mode but the turner motor doesn't do anything! Now what?All you need to do is hold down the okay button, then hit the plus and minus at the same time. It will make the turner engage!
Oh no!Oh no, it puts me into the calibration mode but the turner motor doesn't do anything! Now what?
Edit - It looks like the gear isn't even making contact with the turning bar anymore.
I wish I had more advice. Hopefully someone else will have something helpful for you....I just heard the beep for it go off, but the eggs are in the same position, and the gear looks to be out of contact. Ugh.
The only thing I can suggest is to take out the turning link and make sure it is seated correctly then ensure that all the turners are in their correct spot and lined up.I sat in front of it like a lunatic for a while until it turned. The motor is working, the gear just isn't making contact. Maybe I knocked something loose when I cleaned it last! If that's the case, I may just be able to move it back into place.
I just got done pulling the lid apart and reassembling it; the motor had somehow come out of the groove and that's why it wasn't making contact. It's properly reseated and turning normally again! WHEW.The only thing I can suggest is to take out the turning link and make sure it is seated correctly then ensure that all the turners are in their correct spot and lined up.