DIY CABINET COOLER INCUBATOR How we did it and TEST RUN Ready Set GO!

Date sort Score sort
Steadfast said:
It worked!
I just installed the "Little Giant" thermostat by drilling a hole for the knob and for the red light and 3 more for each wire lead. I then had to tape it because the screws were too short for the cooler wall.


Here are the 3 wire leads which I hooked up.
Black to incoming black
Red to out going black
White to white


Next I used a screw driver to begin adjusting the heat.


Look at the cool red light! It's working!


Things are heating up!


And the light shuts off at 99.5+


And then turns on at 99.5-
Click to expand...
shweet!
 
i think the first one is an EE or amauricana (however it's spelt) and the hello one was hatched from a trader noes eggs so i think it is white leghorn hybrid but i have no idea what the black one is, i think it was laid from a welsummer but i don't know the rooster.
Anyone have corrections or ideas?
 
How long does it take to stabilize the tempiture in one of these? I started mine up last night and I keep swinging 2 degrees too high and 2 dregrees too low.
 
hmmmm adding to oz
@Steadfast all those heat sinks need to warm up too, I would let it run thats alot of water bottles in there!
 

Similar threads

Eldon956
    • Like
DIY Incubator Upgrades...
2
Replies
10
Views
2K
Eldon956
Eldon956
kelseym330
    • Like
questions on DIY incubator
Replies
3
Views
2K
McChooky
McChooky
CanadianGamefowl
Walk-In Incubators
Replies
3
Views
565
CanadianGamefowl
CanadianGamefowl
Squeeing_Onion
    • Like
DIY Incubator - did i do this right?
2 3
Replies
23
Views
4K
Squeeing_Onion
Squeeing_Onion
Jojociita
    • Like
External pip w/THICK membrane and no Peeping
Replies
1
Views
2K
Debbie292d
Debbie292d

New posts New threads Active threads

Back
Top Bottom