Show Off Your American Gamefowl and Chat Thread!!!

[sdm111]

I am going to be renting temporarily close to my current home... Ex is selling our house.. once sold, Ill use my "half" of proceeds to put down payment on new home. Thats the plan at the moment.

*Still fighting to get half because ex is a B

Hope everything goes fairly

 

[rooster 2011]

Hey I know some of y'all are from Oklahoma have any of y'all tried big V feeds for gamefowl

 

[flypen]

That's all I feed

 

[rooster 2011]

That's all I feed

Where do you get yours from since your from Louisiana too I've called several feeds stores I called the Shreveport one the stonewall one and bossier and none of them carry it

 

[JShubin]

 

[SOHC-FTW]

I am going to be renting temporarily close to my current home... Ex is selling our house.. once sold, Ill use my "half" of proceeds to put down payment on new home. Thats the plan at the moment.

*Still fighting to get half because ex is a B

Hope all goes well buddy. And the new place will allow your birds? I know some give ya a hard time about how you raise em but we all know you take good care of em.

 

[SOHC-FTW]

Ima buy me a new truck go in debt and say the heck with it. All four calipers stuck and rusted on I bent one beating it off stinking cast iron, pads, rotors all new now slotted rotors and towing pads. Im going now to get the front calipers. Oh and still waiting on my starter to get here it's dragging and sticking and I can't rightly beat it and turn the ignition by myself lol.
If it wasn't for it being paid for and a good running truck id be even more short tempered, plus I've dumped quite a bit in it to make it run a bit better power wise.

 

[flypen]

Where do you get yours from since your from Louisiana too I've called several feeds stores I called the Shreveport one the stonewall one and bossier and none of them carry it

I buy my feed from DeSoto town and country feed store, in Stonewall

 

[roosterhavoc]

Ima buy me a new truck go in debt and say the heck with it. All four calipers stuck and rusted on I bent one beating it off stinking cast iron, pads, rotors all new now slotted rotors and towing pads. Im going now to get the front calipers. Oh and still waiting on my starter to get here it's dragging and sticking and I can't rightly beat it and turn the ignition by myself lol.
If it wasn't for it being paid for and a good running truck id be even more short tempered, plus I've dumped quite a bit in it to make it run a bit better power wise.

I had an old jeep I got when I was 20 in GA. Finally had to sell it in 2014. Transmission went not long after I replaced the wheel bearings, full brakes, ball joints, tie rods etc.. terrible on gas anyway. Drove that jeep over 10 times back and forth from GA to NJ.

 

[1cock2hens]

My 98 Jeep is on it's last leg engine just got a knock but i think i caught it soon enough. having the motor pulled this week so I can replace the old bearings with some oversized bearings. I'm thinking i want my next car to be an elCamino