Wow not suppose to do that Tonya hurts way to bad 

Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
In a single storm? In the middle of April??30.3 inches is the "official" snow total.
Soak it in hot water with some soap in it! That will make it fester and come outMy work at dad's house was cut rather short today. I drove a splinter under my fingernail and it broke off. I can't get it out and it hurts something awful.
It kind of went in near the edge of my nail so I cut the nail back on the side as far as I could hoping to open up a path for it to come out then packed drawing salve all over it and covered it with a bandage.
It's also hard to type without using that finger...
Oh jeez. Cringe and goosebumps reading that. I bet that does hurt. Hopefully, the salve will draw it out sooner than later!My work at dad's house was cut rather short today. I drove a splinter under my fingernail and it broke off. I can't get it out and it hurts something awful.
It kind of went in near the edge of my nail so I cut the nail back on the side as far as I could hoping to open up a path for it to come out then packed drawing salve all over it and covered it with a bandage.
It's also hard to type without using that finger...
Oooch.My work at dad's house was cut rather short today. I drove a splinter under my fingernail and it broke off. I can't get it out and it hurts something awful.
It kind of went in near the edge of my nail so I cut the nail back on the side as far as I could hoping to open up a path for it to come out then packed drawing salve all over it and covered it with a bandage.
It's also hard to type without using that finger...
Me too.Oooch.Make sure it doesn't get infected!
Betadine gel is quite good with metal splinters I've found. May be worth a try.Me too.
I've been soaking it for over an hour now.
I soaked it for about a minute in alcohol first but the splinter is from plywood.Betadine gel is quite good with metal splinters I've found. May be worth a try.
I get those but thankfully not behind a nail. I should know not to handle ply without gloves on but I still get caught out.I soaked it for about a minute in alcohol first but the splinter is from plywood.