INCUBATING w/FRIENDS! w/Sally Sunshine Shipped Eggs No problem!

Status
Not open for further replies.
Ok I think I was wrong-I think there is a very small outside crack/pip..... like i said its not the best bator-not a clear window-like foggy plastic from the side so it is so hard to tell!!! just leave it?? It doesnt even have a humidity gauge on the outside-i put one on the inside but can see it without opening the lid. Should i just leave it and add a little water for humidity??
 
Oh! A note:


I think how much lockdown matters depends on the bator as well. I think if you have a style of bator you can just crack the lid slightly and do whatever you need to do in a few seconds, it matters less than, say, a brinsea incubator where you remove the entire lid. Obviously, no matter the type of bator, you should be careful, but once or twice isn't a death sentence.
Do they make bators with little lids?! Where can I get one?!!!!!!
 
Ok I think I was wrong-I think there is a very small outside crack/pip..... like i said its not the best bator-not a clear window-like foggy plastic from the side so it is so hard to tell!!! just leave it?? It doesnt even have a humidity gauge on the outside-i put one on the inside but can see it without opening the lid. Should i just leave it and add a little water for humidity??

Yes, ma'am.
 
Coolerbator!
I might just look into that! Hey, a new bator is a good excuse to hatch more eggs, anyways!
big_smile.png
 
Status
Not open for further replies.

New posts New threads Active threads

Back
Top Bottom