Show Off Your American Gamefowl and Chat Thread!!!

[centrarchid]

View attachment 1559251

Shubin, material wise, what did it cost to build pens like those? I want to build four elevated breeding pens for games in the barn that can double as flypens.

 

[1cock2hens]

if you look straight down at the fan in this pic you can see where the blades are just barely touching that piece of the frame. what would cause this to happen? she has been doing fine and right when I got done making a 2 hour drive (literally as i was pulling in the dive) i heard the god awful sound of metal on metal and when i checked it out 4 of the 8 fan blades are hitting? // 98 jeep cherokee 4.0

 

[SOHC-FTW]

Got a fan clutch I'm guessing bearing could be bad on it or the water pump snout bearing. Unless the radiator has shifted toward the firewall due to mounting issues then that would be obvious.

Start it and see if you see a wobble in the pulleys.

 

[1cock2hens]

thank you // I think i'm going to have to have someone come look at it that has a little more knowhow, I started it back up and it's hitting far worse then it was even just last night. it didnt look to be extra wobbly or anything.

 

[SOHC-FTW]

The serpentine belt will hide most of the play/wobble but even the slightest will cause an issue. Try spinning the fan clutch is should have resistance and not spin very much.

 

[SOHC-FTW]

Best of luck bud if I were closer I'd lend a helping hand but only so much one can do over the internet, but if ya got anymore questions holler I'll try an help.

 

[1cock2hens]

thank you, every little idea/suggestion helps and i appreciate it // it feels normal when i spin it by hand (till it hits that metal) // will keep yall posted

 

[Texicano]

 

[roosterhavoc]

 

[hillbilly91]

I would really like to get one of those Easter eggers man