My Hatcher & Incubator!

[Nyla]

The middle pin is what balances the tray. If I take that out, the tray would be off balance and eggs would fall out?

 

[Dmitrys]

Should I do only one connecting beam or one on both sides like my proto?

I made two incubators. I figured out what way is better

The method "each tray" requires high precision drilling otherwise the mounting of the tray will be under heavy load and may break

 

[Dmitrys]

the tray would be off balance

There isn't any problem ) I did like this

 

[WVduckchick]

just following along. Great job so far Nyla!

 

[Nyla]

Your video didn't load. I think I understand your diagram. Can you retry your video?

There isn't any problem ) I did like this

Thank you!

just following along. Great job so far Nyla!

 

[Dmitrys]

Can you retry your video?

pls try to watch it ones again

 

[WVduckchick]

pls try to watch it ones again

That's huge! What do you incubate? Ostriches? Or just thousands of eggs?

 

[Nyla]

Awesome video! Thank you so much! I understand now!

 

[Dmitrys]

That's huge! What do you incubate? Ostriches? Or just thousands of eggs?

I developed it for the 1000 eggs

 

[Nyla]

Please excuse the nasty spots in the fridge, I haven't cleaned it yet.
Here is my new progress!
Tomorrow will be mounting the motor! I also have the temperature controller setup for the incubator part, but didn't get a picture of it!