Pretty cold is 40's you've got ugly,ugly cold lol!
I don't think your girls will mind staying inside one bit. :)

Yeah it is pretty cold. We are forecast for more snow tomorrow. It should be a little warmer then.

I think I will keep all the birds inside until after noon. Days like these I am very glad my coops aren't stuffed full of birds.

Good morning Bob!
I'll try my best to not float away. ;)
:frow Good morning Chicky, have a great day and try to avoid the sog...
 
:tongue It is cold out there!

Dog poops are l PICKED up and chickens are tended. I went ahead and let them out. The sun is shining. The big group....just the smaller birds ventured out....at a dead run to the sheltered area where the sun is actually high enough to hit.
The high should be upper 20's so.....:confused:
 
Last edited:
Upper 20's for highs that sounds better than the 1 degree this morning lol!
Lol, at the dog poops getting died. 🤭
:tongue It is cold out there!

Dog poops are l died up and chickens are tended. I went ahead and let them out. The sun is shining. The big group....just the smaller birds ventured out....at a dead run to the sheltered area where the sun is actually high enough to hit.
The high should be upper 20's so.....:confused:

Limbs are already falling out here, no whole trees yet.
They forecast 3-5" here, and then heavy winds. Trees will be falling! :oops::oops:
 
Upper 20's for highs that sounds better than the 1 degree this morning lol!
Lol, at the dog poops getting died. 🤭


Limbs are already falling out here, no whole trees yet.

Oh FFS! Autocorrect apparently didn't like that they are PICKED up. :rolleyes:

I have the dryer apart....and all the parts check out ok. I came back to look for a schematic for that particular timer. If that thing is ok I will just put it all back together. Not much else to do if nothing tests bad.
 
All the dryer electronics check out ok.
The ONLY thing I found is one drum roller is kinda sticky. If that is causing drag on the drum the motor can be overheating and trigger its internal overload switch. :confused: If that is it but if I replace motor, rollers, idler, and belt the total cost is still under $100.
 

New posts New threads Active threads

Back
Top Bottom