- Thread starter
- #21
FluffTheDuck
Duck love is recognizable in any language
One of my hobbies is feather glittering. I'll show you how to do it:
What you will need:
The glue way:
*Feathers
*Scissors
*Glue
*Yarn
*Small ring
*Protective towel for area
*Glitter
*Tape
*Sponge
Step one: TAPE your feather to the protective towel, at the stem of the feather.
Step two: APPLY a small amount of glue to the sponge.
Step three: SOAK the end of the feather with the glue. (Not the end that you taped!)
Step four: APPLY glitter all over the area that was soaked with glue.
Step five: CUT the tape and remove the feather from the towel, making sure the tape is removed.
Step six: TAPE the feather that's right below the stem, that is not soaked in glitter.
Step seven: APPLY a very small amount of glue to the sponge.
Step eight: SOAK the stem (again, not the one with glitter on it!) of the feather.
Step nine: PLACE a small ring on the stem.
Step ten: APPLY even more glue to the stem and ring.
Step eleven: WAIT to dry.
Step twelve: MEASURE your neck by putting yarn around it, leaving a little excess, and enough yarn for you to take it off.
Step thirteen: SOAK the ends of the yarn with soapy water.
Step fourteen: TAPE the two ends of the yarn onto the protective towel.
Step fifteen: PRESS the ends of the yarn and twist, to make the yarn thin at the ends.
Step sixteen: THREAD your now-dry feather onto the yarn.
Step seventeen: KNOT the ends of your yarn together, and wallah! You have a feathered necklace!
The yarn way:
*Feathers
*Scissors
*Glue
*Yarn
*Small ring
*Protective towel for area
*Glitter
*Tape
*Sponge
Step one: TAPE your feather to the protective towel, at the stem of the feather.
Step two: APPLY a small amount of glue to the sponge.
Step three: SOAK the end of the feather with the glue. (Not the end that you taped!)
Step four: APPLY glitter all over the area that was soaked with glue.
Step five: CUT the tape and remove the feather from the towel, making sure the tape is removed.
Step six: TAPE the feather that's right below the stem, that is not soaked in glitter.
Step seven: GET a small piece of yarn, and thread a small ring on it.
Step eight: TIE the ring to the stem of the feather.
Step nine: MEASURE your neck by putting yarn around it, leaving a little excess, and enough yarn for you to take it off.
Step ten: SOAK the ends of the yarn with soapy water.
Step eleven: TAPE the two ends of the yarn onto the protective towel.
Step twelve: PRESS the ends of the yarn and twist, to make the yarn thin at the ends.
Step thirteen: THREAD your feather onto the yarn.
Step fourteen: TIE knots onto the ends of the necklace, and wallah!
What you will need:
The glue way:
*Feathers
*Scissors
*Glue
*Yarn
*Small ring
*Protective towel for area
*Glitter
*Tape
*Sponge
Step one: TAPE your feather to the protective towel, at the stem of the feather.
Step two: APPLY a small amount of glue to the sponge.
Step three: SOAK the end of the feather with the glue. (Not the end that you taped!)
Step four: APPLY glitter all over the area that was soaked with glue.
Step five: CUT the tape and remove the feather from the towel, making sure the tape is removed.
Step six: TAPE the feather that's right below the stem, that is not soaked in glitter.
Step seven: APPLY a very small amount of glue to the sponge.
Step eight: SOAK the stem (again, not the one with glitter on it!) of the feather.
Step nine: PLACE a small ring on the stem.
Step ten: APPLY even more glue to the stem and ring.
Step eleven: WAIT to dry.
Step twelve: MEASURE your neck by putting yarn around it, leaving a little excess, and enough yarn for you to take it off.
Step thirteen: SOAK the ends of the yarn with soapy water.
Step fourteen: TAPE the two ends of the yarn onto the protective towel.
Step fifteen: PRESS the ends of the yarn and twist, to make the yarn thin at the ends.
Step sixteen: THREAD your now-dry feather onto the yarn.
Step seventeen: KNOT the ends of your yarn together, and wallah! You have a feathered necklace!
The yarn way:
*Feathers
*Scissors
*Glue
*Yarn
*Small ring
*Protective towel for area
*Glitter
*Tape
*Sponge
Step one: TAPE your feather to the protective towel, at the stem of the feather.
Step two: APPLY a small amount of glue to the sponge.
Step three: SOAK the end of the feather with the glue. (Not the end that you taped!)
Step four: APPLY glitter all over the area that was soaked with glue.
Step five: CUT the tape and remove the feather from the towel, making sure the tape is removed.
Step six: TAPE the feather that's right below the stem, that is not soaked in glitter.
Step seven: GET a small piece of yarn, and thread a small ring on it.
Step eight: TIE the ring to the stem of the feather.
Step nine: MEASURE your neck by putting yarn around it, leaving a little excess, and enough yarn for you to take it off.
Step ten: SOAK the ends of the yarn with soapy water.
Step eleven: TAPE the two ends of the yarn onto the protective towel.
Step twelve: PRESS the ends of the yarn and twist, to make the yarn thin at the ends.
Step thirteen: THREAD your feather onto the yarn.
Step fourteen: TIE knots onto the ends of the necklace, and wallah!