@BY Bob - Electric fence power - long post, but is it what you want to know? I have been learning about these things myself!

Here is the unit that converts the power and pulses it, sending zaps along the positive line out to the fence. The grounding is here also, very bottom of picture, the line goes to a long ground rod. I drove the rod pretty deep because it's sort of where we store bikes and other things and I don't want it sticking out even four inches. The rod is like a couple feet long. The unit needs shelter of some kind. This is the ground floor of our hybrid pole-barn / truss garage. Sander is circa 60's or possibly earlier....DH saves everything. Notice the toaster oven under the box next to the wire roll? :lau
PXL_20220825_125359285~2.jpg

The wire roll is the remaining wire from a 500 foot roll. I won't cut it until I've run this for a while as I'm not sure of the length I need eventually. The exact footage they had precut was probably good, but maybe not, and this was the next step up. The Premier guy advised no splices. Since I've never done this kind of thing I wanted to allow for do-overs!

Ground rod close-up. Band clamp attaching the wire. I need to hammer in some staples along the wire paths. After I did the nails I spoke to DH and of course he had a little box of staples somewhere!
PXL_20220825_125417036.jpg


The unit is powered by a wall wart into an outlet to the right of the wagon tires in the first pic.
PXL_20220825_125426872.MP~2.jpg


Out the window and across the swale. Cleared the setup plan with Premier, told them I didn't want to bury the line because wood delivery and any other trucks (septic guy) need to go around here. The yellow line is the extension cord used only for waterer and coop warming panel in winter, nothing to do with the fence, but you can find the black fence wire by finding it.
PXL_20220825_184052627.MP.jpg


Into the woods, I need to fix the lines taut better, does anybody know what you get to hold on to a line and then fix it to something? Some kind of Gripple? It needs to grip but not pierce or pinch. All I found were for going out of electric boxes and those have teeth. I used two zip ties, one around the wire, the other hooked into it, & effort made to not pinch anything. That orange box is for the extension cord, it's a weather tight connection box for another length (think this 150 feet is fine, I'm not operating power tools on the far end, it's very low draw). After here both lines go along the crooks of trees over towards the fence. There's a ski path below to the right.
PXL_20220825_163007792~2.jpg


Fence end, yellow extension cord is coiled up in the back. There's a handy tree limb that goes over the path so the wire comes down after the path to the fence posts.
Now the clip ("Powerlink") from the fence to the cutoff switch is attached, those are the orange "jumper cable" jaws. Volts are good, no loss due to the long roll of wire. The guy at Premier recommended the next higher Energizer unit than I was thinking, one joule instead of half a joule, because of the length of fence I have and could use. Not sure actually if the cable length is an issue. Anyway, it works!
PXL_20220825_155340670.MP.jpg


I've gone to the barrier of aviary netting between them and the electric fence. They are familiar with the aviary netting and know they can touch it and browse under it, but they are very wary of the white poultry netting and stay away. I worry less this way and there is no temptation to get at wonderful greens that could get them zapped. There was an occasional zap last year and even though it's quick it does hurt. I do watch them when they are out of their aviary area with me and anywhere near the dreaded fence. However they've been very good with staying away, no zaps at all this year. I see them look at a green near it and decide against it.
An electrifying topic, they agree! ❤️
PXL_20220811_205438731.jpg
 
🤦‍♂️ Why did I ever say that? Why Bob? Why? 🤦‍♂️

You so deserve this. :oops:
Well, you are correct in terms of 'standard meat animals', and also regarding Ducks the cornishX are quicker to processing...just the first four weeks the explosion of growth of the ducks is unlike any other animal I have seen! (note: I have NOT intentionally ever watched insects grow.) So, you are still correct in what your intentions are/were. And you are still the master::bow that we all ❤️ :hugs

I will have to plow through my pics and see if I can find some of the ducks as wee babies/2-3 days old at arrival and then some at around 4 weeks.
 
Last edited:
The crew! They all ran up and thanked me for saving their sister it was so sweet I had no food and they have never done that before!

View attachment 3235696View attachment 3235697View attachment 3235698View attachment 3235699View attachment 3235700View attachment 3235701View attachment 3235702
You could put some cardboard along the base of the fence, at chick-height, to prevent that happening again. Chickenwire isn't great for chicks for this reason, but a barrier of some kind is a solution.
 
@BY Bob - Electric fence power - long post, but is it what you want to know? I have been learning about these things myself!

Here is the unit that converts the power and pulses it, sending zaps along the positive line out to the fence. The grounding is here also, very bottom of picture, the line goes to a long ground rod. I drove the rod pretty deep because it's sort of where we store bikes and other things and I don't want it sticking out even four inches. The rod is like a couple feet long. The unit needs shelter of some kind. This is the ground floor of our hybrid pole-barn / truss garage. Sander is circa 60's or possibly earlier....DH saves everything. Notice the toaster oven under the box next to the wire roll? :lau
View attachment 3235540
The wire roll is the remaining wire from a 500 foot roll. I won't cut it until I've run this for a while as I'm not sure of the length I need eventually. The exact footage they had precut was probably good, but maybe not, and this was the next step up. The Premier guy advised no splices. Since I've never done this kind of thing I wanted to allow for do-overs!

Ground rod close-up. Band clamp attaching the wire. I need to hammer in some staples along the wire paths. After I did the nails I spoke to DH and of course he had a little box of staples somewhere!
View attachment 3235528

The unit is powered by a wall wart into an outlet to the right of the wagon tires in the first pic.
View attachment 3235527

Out the window and across the swale. Cleared the setup plan with Premier, told them I didn't want to bury the line because wood delivery and any other trucks (septic guy) need to go around here. The yellow line is the extension cord used only for waterer and coop warming panel in winter, nothing to do with the fence, but you can find the black fence wire by finding it.
View attachment 3235647

Into the woods, I need to fix the lines taut better, does anybody know what you get to hold on to a line and then fix it to something? Some kind of Gripple? It needs to grip but not pierce or pinch. All I found were for going out of electric boxes and those have teeth. I used two zip ties, one around the wire, the other hooked into it, & effort made to not pinch anything. That orange box is for the extension cord, it's a weather tight connection box for another length (think this 150 feet is fine, I'm not operating power tools on the far end, it's very low draw). After here both lines go along the crooks of trees over towards the fence. There's a ski path below to the right.
View attachment 3235557

Fence end, yellow extension cord is coiled up in the back. There's a handy tree limb that goes over the path so the wire comes down after the path to the fence posts.
Now the clip ("Powerlink") from the fence to the cutoff switch is attached, those are the orange "jumper cable" jaws. Volts are good, no loss due to the long roll of wire. The guy at Premier recommended the next higher Energizer unit than I was thinking, one joule instead of half a joule, because of the length of fence I have and could use. Not sure actually if the cable length is an issue. Anyway, it works!
View attachment 3235559

I've gone to the barrier of aviary netting between them and the electric fence. They are familiar with the aviary netting and know they can touch it and browse under it, but they are very wary of the white poultry netting and stay away. I worry less this way and there is no temptation to get at wonderful greens that could get them zapped. There was an occasional zap last year and even though it's quick it does hurt. I do watch them when they are out of their aviary area with me and anywhere near the dreaded fence. However they've been very good with staying away, no zaps at all this year. I see them look at a green near it and decide against it.
An electrifying topic, they agree! ❤️
View attachment 3235720
I believe the ground rod works best if the soil around it is damp - how do you achieve that when it is underneath a building? I put mine near the wash out of the sump pump drain and I actually put in three of them I think!
I am going to have to retrain everyone on the fence - I have had it turned off for a month because it has been so dry I was worried about starting a fire - but I have noticed that the raccoons have figured out it is off and are stopping by at night to see if they can break in!
 
New Layer! New Layer!
One of my teens has started laying. Not sure which one, but I have BCMs and Welsummers...I am pretty sure it is one of my BCMs because they had started getting redder combs and wattles a few weeks ago. The Welsummers are definitely behind them in that regards. It could be any one of 3 (out of 6) of the BCMs.
IMG_1770.JPG


The egg on the right is from my new laying girl.
 
Last edited:
New Layer! New Layer!
One of my teens has started laying. Not sure which one, but I have BCMs and Welsummers...I am pretty sure it is one of my BCMs because they had started getting redder combs and wattles a few weeks ago. The Welsummers are definitely behind them in that regards. It could be any one of 3 (out of 6) of the BCMs.View attachment 3235853
Looks like a BCM egg to me. Congrats on the new layer.
 
@BY Bob - Electric fence power - long post, but is it what you want to know? I have been learning about these things myself!

Here is the unit that converts the power and pulses it, sending zaps along the positive line out to the fence. The grounding is here also, very bottom of picture, the line goes to a long ground rod. I drove the rod pretty deep because it's sort of where we store bikes and other things and I don't want it sticking out even four inches. The rod is like a couple feet long. The unit needs shelter of some kind. This is the ground floor of our hybrid pole-barn / truss garage. Sander is circa 60's or possibly earlier....DH saves everything. Notice the toaster oven under the box next to the wire roll? :lau
View attachment 3235540
The wire roll is the remaining wire from a 500 foot roll. I won't cut it until I've run this for a while as I'm not sure of the length I need eventually. The exact footage they had precut was probably good, but maybe not, and this was the next step up. The Premier guy advised no splices. Since I've never done this kind of thing I wanted to allow for do-overs!

Ground rod close-up. Band clamp attaching the wire. I need to hammer in some staples along the wire paths. After I did the nails I spoke to DH and of course he had a little box of staples somewhere!
View attachment 3235528

The unit is powered by a wall wart into an outlet to the right of the wagon tires in the first pic.
View attachment 3235527

Out the window and across the swale. Cleared the setup plan with Premier, told them I didn't want to bury the line because wood delivery and any other trucks (septic guy) need to go around here. The yellow line is the extension cord used only for waterer and coop warming panel in winter, nothing to do with the fence, but you can find the black fence wire by finding it.
View attachment 3235647

Into the woods, I need to fix the lines taut better, does anybody know what you get to hold on to a line and then fix it to something? Some kind of Gripple? It needs to grip but not pierce or pinch. All I found were for going out of electric boxes and those have teeth. I used two zip ties, one around the wire, the other hooked into it, & effort made to not pinch anything. That orange box is for the extension cord, it's a weather tight connection box for another length (think this 150 feet is fine, I'm not operating power tools on the far end, it's very low draw). After here both lines go along the crooks of trees over towards the fence. There's a ski path below to the right.
View attachment 3235557

Fence end, yellow extension cord is coiled up in the back. There's a handy tree limb that goes over the path so the wire comes down after the path to the fence posts.
Now the clip ("Powerlink") from the fence to the cutoff switch is attached, those are the orange "jumper cable" jaws. Volts are good, no loss due to the long roll of wire. The guy at Premier recommended the next higher Energizer unit than I was thinking, one joule instead of half a joule, because of the length of fence I have and could use. Not sure actually if the cable length is an issue. Anyway, it works!
View attachment 3235559

I've gone to the barrier of aviary netting between them and the electric fence. They are familiar with the aviary netting and know they can touch it and browse under it, but they are very wary of the white poultry netting and stay away. I worry less this way and there is no temptation to get at wonderful greens that could get them zapped. There was an occasional zap last year and even though it's quick it does hurt. I do watch them when they are out of their aviary area with me and anywhere near the dreaded fence. However they've been very good with staying away, no zaps at all this year. I see them look at a green near it and decide against it.
An electrifying topic, they agree! ❤️
View attachment 3235720
I love her expression (the one back left!) ❤️ ❤️
 

New posts New threads Active threads

Back
Top Bottom