Here is my tax offering for complaining about the cold when I know several of you are dealing with colder weather.
DSCN6105.JPG
 
I have 2 comments to make before you build the rest of the coop. (will make a nice coop!)

1) The directions for the door are a bit flawed. As you see, you DO need a header. However, since they measured 36" BEFORE accounting for the extra side studs to support the header, their door opening is actually only 32 3/4 " wide. So, whatever size door you want, be sure to allow for the width of the 2 extra studs (1 each side) in the opening.

2) NEVER screw metal or plastic corrugated roofing on the low part of the curve. Even with roofing screws, it is asking for trouble (leaks) sooner than it should. Use these spacers , and screw through the HIGH point of the corrugation:
https://www.homedepot.com/p/Suntuf-...Closure-Strips-6-Pack-92770/100067957#overlay

They go under roofing panel @ roof member, screw through panel, through plastic 'spacer', and into roof support member.

A couple final comments:
1) I don't know where in VA you live, but if in the mountains or somewhere where it gets cold, I would suggest putting either a sheet of plywood (painted/stained) under the metal roofing, or a thin insulation (the silver-colored bubble stuff would be fine. REASONING: In winter, moisture from the chickens will condense on the cold metal roof and 'drip down', in the summer, the metal roof will heat up, creating a hotter than needed coop in the dog days of summer. Either the plywood or thin insulation will help with this.

2) As suggested that you can add windows: I definitely would add 2, one on each side, for cross ventilation and added light.

3) Low ventilation in the back for better air flow...in low (cooler air)...warm moist air rises up and out the top back. (i.e. vents low below the high riser for roof)

4) Consider orienting the high part of the roof the front instead of the back, unless you are going to put gutters on. Otherwise you will be walking through a sheet of rain/water whenever it storms & you need to enter/exit the coop.

Okay, that's my 2 cents💰, for what ever 2 cents is worth these days.🤷‍♀️
These are all great advice. Great job taking a close look at the plans. I did not.
 
Outside in the Bitter Cold

I should have locked them in last night. These knuckleheads came out first thing this morning.

View attachment 2974052
View attachment 2974056

The Polish are still in the garage. At least until 9 am. I am monitoring the temp.
It just hit 10F here and it is a lot warmer in the Chicken Palace. Dotty is finishing a private breakfast in the garage and then I will take her back to join her friends.
She really doesn't like me - she went all out banshee with pecking when I brough her breakfast. Every time she lunged for me she lost a whole pile more feathers.
Sigh.
 
I have 2 comments to make before you build the rest of the coop. (will make a nice coop!)

1) The directions for the door are a bit flawed. As you see, you DO need a header. However, since they measured 36" BEFORE accounting for the extra side studs to support the header, their door opening is actually only 32 3/4 " wide. So, whatever size door you want, be sure to allow for the width of the 2 extra studs (1 each side) in the opening.

2) NEVER screw metal or plastic corrugated roofing on the low part of the curve. Even with roofing screws, it is asking for trouble (leaks) sooner than it should. Use these spacers , and screw through the HIGH point of the corrugation:
https://www.homedepot.com/p/Suntuf-...Closure-Strips-6-Pack-92770/100067957#overlay

They go under roofing panel @ roof member, screw through panel, through plastic 'spacer', and into roof support member.

A couple final comments:
1) I don't know where in VA you live, but if in the mountains or somewhere where it gets cold, I would suggest putting either a sheet of plywood (painted/stained) under the metal roofing, or a thin insulation (the silver-colored bubble stuff would be fine. REASONING: In winter, moisture from the chickens will condense on the cold metal roof and 'drip down', in the summer, the metal roof will heat up, creating a hotter than needed coop in the dog days of summer. Either the plywood or thin insulation will help with this.

2) As suggested that you can add windows: I definitely would add 2, one on each side, for cross ventilation and added light.

3) Low ventilation in the back for better air flow...in low (cooler air)...warm moist air rises up and out the top back. (i.e. vents low below the high riser for roof)

4) Consider orienting the high part of the roof the front instead of the back, unless you are going to put gutters on. Otherwise you will be walking through a sheet of rain/water whenever it storms & you need to enter/exit the coop.

Okay, that's my 2 cents💰, for what ever 2 cents is worth these days.🤷‍♀️
Wise advice on all fronts.
 
Outside in the Bitter Cold

I should have locked them in last night. These knuckleheads came out first thing this morning.

View attachment 2974052
View attachment 2974056

The Polish are still in the garage. At least until 9 am. I am monitoring the temp.
I am finding that as long as no draft/wind they seem fine. I worried these last few weeks but they seemed ok...
 

New posts New threads Active threads

Back
Top Bottom